"SAW
BUCK"™ chain saw chaps offer greater
protection and comfort than previously attainable with
ballistic nylon chaps. The difference is the use of a
combination of woven Kevlar® and needle punch Kevlar®
fabrics which pound for pound are five times stronger
than steel! U.S. Forest Service tests show that the
combination Kevlar® fabrics used in "SAW
BUCK"™ chaps allow substantially more
reaction time in event of an accident - this additional
time could prevent a serious injury.
50% more
protection than ballistic nylon chaps.
Light
weight (chaps weigh approximately 2 lbs.).
Excellent flexibility.
Cordura®
nylon outer shell has 5 times the abrasion
resistance of cotton and has polyurethane
coating for oil and water resistance. Edges
bound with strong nylon binding.
Made in
accordance with U.S. Forest Service
Specification No. 6170-4d. All materials and
workmanship are thoroughly inspected before
any chaps leave our plant.
Mildew and
rot resistant. Quick drying. To clean, wash
using scrub brush, warm water and detergent.
Stubborn stains may require treating first
with a dry cleaning solvent.
|
Available in
four lengths
(Measure from waist
to desired length.)
Regular 28"
Long 32"
XLong 36"
XXLong 40"
Warranty:
PGI,
Inc. warrants the "SAW BUCK"™
chain saw chap against defects in manufacture
only. However, because of varied uses and
applications for use of this chap, no warranty is
made, or should be implied, regarding use of the
chap. The chap is not a substitute for safe
operating procedures, or for properly functioning
equipment. It will be the buyer's responsibility
to determine if this product adequately protect
the user.
|
Note: For maximum
protection chaps length should be two inches below boot
tops.
|
